Skip to content

Posts Tagged ‘chisel’

Sharpening a Gouge

Note: This is the sharpening process of an out-cannel gouge. Paul recommends 2 methods to sharpen an out-cannel gouge which can both be done on diamond plates or abrasive paper. You will also need a curved strop, which you can make yourself, to polish at the end of the sharpening process, for this you will…

Read More

Using a Gouge

You can drive the gouge into the wood using a chisel hammer or mallet or use hand and arm pressure only. You can use them to pare cut, depending on the gouge type. The gouge can make shallow or deep cuts depending on the pressure applied, if you are using it to hollow, you would…

Read More

Buying a Gouge

Paul recommends the Ashley Iles No7 37mm straight gouge to use in spoon and bowl carving. He also uses and recommends Pfeil and Hirsch in similar size and sweep, however these brands are not always in stock. We found the Stubai 40mm No7 to be in stock from Tiranti which is £37 and is just…

Read More

Setting Up and Sharpening a Chisel

Note: Be careful when sharpening as the tools will become very sharp, always face the blade away from you when sharpening. This guide will show you the process of how to sharpen a chisel using diamond stones and the process of how to sharpen a chisel using abrasive paper. Paul recommends diamond stones, however if…

Read More

Using a Chisel

When chopping paring or splitting, you should ensure the chisel is presented to the wood at the appropriate angle. PARE When you are paring wood you should rely on hand pressure only and use both hands to present the chisel to the wood. With your dominant hand on the handle and the other wrapped around…

Read More

Buying a Chisel

When buying chisels, you will usually find a set of 4 or a set of 6. The set of 4 includes the 4 most common sizes listed below and the set of 6 includes the two additional sizes: ¼” (6mm) ½” (12mm) ¾” (18mm) 1” (25mm) and 2 additional sizes ⅜” (10mm) 1¼” (32mm) Some…

Read More

The Chisel Guide

Chisels are one of the most commonly used tools in the history of woodworking. They are made up of a steel blade attached either to a wooden or plastic handle. Chisel hammers and wooden mallets are the tools we use to strike the end of the handle to allow you to split, chop and pare…

Read More
[login_form]

Forgot your password? Click Here


Need an account? Register Now