How to Make a Three-Legged Stool

For this project you will need:
- Wood:
- Stool Seat: 12 ¼ “ (311mm) x 12 ¼ (311mm) x 1 3/8” (35mm) This will be shaped for a finish size of 12” (305mm). You can make this up from a different combination of pieces, Paul uses 4 pieces for the top in this course
- Leg (x3): 13” (330mm) x 1 ⅝ “ (41mm) x 1 ⅝ “ (41mm) before shaping
- Thin scrap of wood more than half your stool seat diameter
- Scraps to make wedges from
- Glue
- Abrasive Paper
- Nail/ Pin
- Shellac and Hake Brush
- Sash Clamps
- Dovetail Template
- Spirit Level
- Coin/washer (optional)
- Pencil
- Chisel Hammer
- Plane
- Spokeshave
- Brace and Bit
- Steel Rule
- Tape Measure
- Card Scraper
- Steel Hammer
- Square
- Panel Saw
- Chisel
- Sliding Bevel
- Tenon Saw