The Combination Gauge Guide
…the fixed pin, then set the moveable pin to the width of the chisel. Position the chisel just inside the tips of the pins (refer to picture for positioning)…. Read…
…the fixed pin, then set the moveable pin to the width of the chisel. Position the chisel just inside the tips of the pins (refer to picture for positioning)…. Read…
…is moveable. Place the chisel against the fixed pin, then set the moveable pin to the width of the chisel. Position the chisel just inside the tips of the pins…
…knot free, durable hardwood will work best) Pencil Steel Rule Card scraper Knife File Router Plane or Marking Gauge Dovetail and Tenon saw 1″ Chisel Make sure all your faces have been…
Once dry, you must plane the outsides of the box. First, use the corner of a sharp chisel to pare cut any protruding nubs if there are any. This will…
…Then proceed to cut the shoulders, followed by the cheeks, and clean out the shoulders with a sharp chisel. The beam on a standard square is 1″ (25mm) Centre your…
…wood, and then using a chisel to create a stepdown so that other tools (chisels, saws, etc) can be used to precisely align them to the knifewall. Whereas it is…
…shellac. Check that you are not pulling the grain up Your chisel should be newly sharpened You can now apply some finish Your chisels now have a safe home Why…
…Up and Sharpening a Chisel Sharpening Tools and Accessories Setting Up and Sharpening a Woodworker’s Knife Setting Up a Square Setting Up and Sharpening a Plane Setting Up a Hammer…
…to remove the excess. If there is a minor amount of glue around the joint, leave to harden, then when it is dry use a chisel, plane or scraper to…
…Buffing compound (aluminum oxide) Strop (block of plywood with leather glued on to cover one surface) The plane blade is sharpened in a similar way to the chisel, to read…