How to Make a Dovetailed Box
…Tape Dovetail Saw Chisel ¼” (6mm), ½” (13mm), ¾” (19mm) [Optional- 1” (25mm)] Chisel Hammer Plane Square Handsaw Knife Gauge Screwdriver Square Awl (Can use a nail and steel hammer…
…Tape Dovetail Saw Chisel ¼” (6mm), ½” (13mm), ¾” (19mm) [Optional- 1” (25mm)] Chisel Hammer Plane Square Handsaw Knife Gauge Screwdriver Square Awl (Can use a nail and steel hammer…
…6mm chisel to measure the haunch but you can use a steel rule to measure this if you don’t have that size) Chisel hammer Knife Tenon Saw Router plane (Optional)…
…to remove after the finish is applied. Use a sharp chisel or a plane depending on the size and location of the area. Paul uses a hake brush this is…
…x ¾” (approx. 20cm x 35cm x 19mm) Tools: Coping Saw (or a 1″ Chisel, Chisel Hammer and Tenon Saw) Spokeshave Round rasp Round file Plane Pencil Workmate® or workbench…
…of the cutting board by skewing the plane. Go with the flat side on the extremes and switch to the round closer to the middle. You can try to use…
…is best). Paul recommends the 3” (76mm) x 8” (203mm) diamond stones from EZELAP, this width is so you can comfortably fit the width of a chisel and a plane…
…Shellac and Hake Brush Sash Clamps Dovetail Template Spirit Level Coin/washer (optional) Pencil Chisel Hammer Plane Spokeshave Brace and Bit Steel Rule Tape Measure Card Scraper Steel Hammer Square Panel Saw Chisel…
…off the bulk of the waste, concentrating primarily on the ends until you are closer to your layout markings on the ends. Start with a heavy set on your plane…
…piece of wood against it in the vise. Use a plane to take off any high spots. Do this on the other face and repeat on the other three table…
If the top of the legs are higher than the aprons you can add a slight bevel to the inside edges which will allow you to plane them flush without…