[…] (76mm) wide x 10” (254mm) long (any type of wood you can spare but needs to be flat on the top face) Double sided tape Buffing compound Knife Start by covering the top face your wood with double sided tape to hold the leather, make sure nothing gets caught underneath the tape as you […]
[…] For the Angled Cuts exercise, the only tools you need is the saw, sliding bevel and the square. If you have all of these and a woodworkers knife, you can do the Crosscut and Ripcut exercise. For the Round Rod exercise, the only tool you need is a plane. So depending on your tool […]
[…] 2): 16” (406mm) x 5½ ” (140mm) x ¾ (19mm) Handle: 1″ (25mm) dowel 20″ (508mm) long Pegs: ¾” (19mm) x 2” (51mm) Tools: Plane Spokeshave Gauge Knife Steel rule Square Panel saw Tenon saw Brace and 1″ bit Drill and drill bit Chisel 1” (25mm) and ½ “ (13mm) Router plane Pencil Other […]
[…] for this project. To see the video version of this guide on our sister site, Woodworking Masterclasses, click here. For this project you will need: Pencil Square Knife Chisel Chisel Hammer Rasp/File Gauge Router Plane Tape measure Tenon Saw Spokeshave Abrasive Paper Shellac and Hake Brush Glue Sash Clamps Arch PDF: (UK Template) (US […]
[…] results in the two surfaces being flush at the front with no part of the joint showing. If you haven’t already done so, we recommend you have a go at the regular housing dado course before moving on to these variations. To make these joints, you will need: Pencil Square Knife Chisel Chisel Hammer Router
[…] how to glue up two bards together. Tools Pencil Steel Rule / Tape Dovetail Saw Chisel ¼” (6mm), ½” (13mm), ¾” (19mm) Chisel Hammer Plane Square Handsaw Knife Gauge Screwdriver Square Awl (Can use a nail and steel hammer if you don’t have a square awl) #80 scraper (Optional) Sash Clamps Dovetail Template Hardware and […]
[…] and the other ¾” (19mm) x 2 ¾” (70mm). Tools Pencil Square Combination Gauge Chisel ⅜ ” (10mm) and a ¾“ (19mm) (Paul uses a 6mm chisel to measure the haunch but you can use a steel rule to measure this if you don’t have that size) Chisel hammer Knife Tenon Saw Router plane (Optional)
We strongly recommend you have a go at the regular dovetail course before starting this one. For this course you will need: 2 pieces of wood- ½” (13mm) x 3 ½” (89mm) x 5” (127mm) Square Pencil Dovetail Template Dovetail Saw Knife Chisel– ¾ (19mm), ½ (13mm), and ⅜ (10mm) Chisel Hammer
[…] the combination square, however unlike the combination square, it can be set at any angle. The tool is often used alongside other tools such as the layout knife to create precise markings for joints. Terminology Stock – The heavier part which is used to rest against the edge of the wood Beam – The […]
[…] are gaps, it doesn’t mean that this dovetail won’t stay together. If you glued this up, it could last for 100 years. The Importance of Using a knifewall Paul takes the joint apart (remember to use a rubber faced hammer to avoid hammer marks damaging the surface) and checks for an uneven surface between […]