Cutting with Crosscut and Ripcut
You will need: 2 x pieces of wood (scrap wood will work for this) Ripcut Saw Crosscut Saw Pencil Square Knife Ripcut Draw a line about 1” (25mm) from the…
You will need: 2 x pieces of wood (scrap wood will work for this) Ripcut Saw Crosscut Saw Pencil Square Knife Ripcut Draw a line about 1” (25mm) from the…
…of this guide on our sister site, Woodworking Masterclasses, click here. For this project you will need: Pencil Square Knife Chisel Chisel Hammer Rasp/File Gauge Router Plane Tape measure Tenon…
Although square edges have a pleasing look, you may wish to round over the three long, front edges and the sides of the top and bottom pieces. This will give…
…of our courses. For the Angled Cuts exercise, the only tools you need is the saw, sliding bevel and the square. If you have all of these and a woodworkers…
…you have a go at the regular housing dado course before moving on to these variations. To make these joints, you will need: Pencil Square Knife Chisel Chisel Hammer Router…
…(presumably the front edge). Simply use the shelf piece to mark the exact width on your side piece. Remember to lay out with a square and pencil first (including the…
…crisp and square to the length of the recess, especially if the housed piece won’t have a notch to conceal the end of the recess. Take out the bulk gradually…
Ensure all your boards have been trued and are square, to see how to do this, see our Truing Stock guide. For this you will need: Pencil Plane Handsaw #80…
…2 pieces of wood- ½” (13mm) x 3 ½” (89mm) x 5” (127mm) Square Pencil Dovetail Template Dovetail Saw Knife Chisel– ¾ (19mm), ½ (13mm), and ⅜ (10mm) Chisel Hammer…
…the edges out of square. Make sure to work with the grain; the transitions on the corners are particularly prone to tearout, so pay close attention and turn around if…