The Chisel Hammer Guide

Chisel hammer is the term used by Paul Sellers to describe the hammer that he recommends for use in striking the end of the chisel handle and assembling joinery. It can be made from nylon, steel or brass. The type Paul Sellers recommends is sold as a ‘nylon hammer’, ‘assembly hammer’ or even a ‘soft-faced hammer’. You can buy them in weights and sizes that better suit your particular hand size and or physical strength, arm length and so on.

Uses

The chisel hammer is used to strike the end of the chisel handle to chop and cut wood. It is also used in assembling joinery when building furniture and other woodworking crafts. The nylon faces are less damaging to the wood when used directly on the wood than their steel counterparts would be. In general this type of hammer is now often used as a replacement for the traditional wooden mallet though wooden mallets are still popular. To read more about using a chisel hammer, click here.

Terminology

  • COP – Centre of Percussion, that is, the optimum point on the hammer face that allows the best transfer of energy into whatever you are striking
  • Claw hammer – A hammer with a split claw-like hook at one end to help lever nails out of wood.
  • Face – The round surface(s) on the end of the hammer head.

Types of Chisel Hammers

Whereas you can use steel claw hammers to strike chisels, the chisel handles must be split resistant plastic. You can also use wooden mallets, however, Paul Sellers recommends a chisel hammer as it has a smaller head so you are more likely to hit more precisely on the ‘centre of percussion’ (COP) which is where you will get the most effective strike. As the head of a traditional wooden mallet is large, you have less chance of hitting the COP.

Parts of a Chisel Hammer

● Handle

● Rubber Face

● Nylon Face

● Head

Relevant Guides

  • Setting Up a Hammer

    Setting Up a Hammer

    Note: This guide is on both chisel hammers and warrington hammers. Paul recommends scraping off the varnish from the handle when you get a new wooden-handled hammer and he recommends adding 4 coats of boiled linseed oil over a few days. This finish will ensure the hammer handle keeps in great condition and lasts a long…

    Read More

  • Using a Chisel Hammer

    Using a Chisel Hammer

    To get the most from your hammer, you need to get the weight and balance ratio right. The Centre of Percussion (COP) is the optimum point on the hammer face that allows the best transfer of energy into whatever you are striking. With smaller hammers there is little you can do to take advantage of…

    Read More

  • Buying a Chisel Hammer

    Buying a Chisel Hammer

    Called a chisel hammer by Paul Sellers, when being sold they can be listed as a ‘nylon hammer’, ‘assembly hammer’ or even a ‘soft-faced hammer’. Paul Sellers prefers a nylon faced hammer, (31-712R Thorex Nylon Hammer) his preferred size is is a 1 ½” (38mm). The head of the hammer is made from steel which has…

    Read More


Further Reading

To read more on this we recommend the following from Paul’s blog:

Hammers for Chisels- Many Choices

Similar Posts

Leave a Reply